Products
CNC With Emergency Stop Electronic Handwheel Hand Pulse Handheld Box Machining Center Engraving Machine CNC machine Pulse Generator
Hand Wheel Information:
|
Product Name |
Manual Pulse Generator/CNC Manual hand wheel |
|
Material |
PA ABS Metal |
|
Resolution |
25 Pulse normally 100 Pulse |
|
Working Voltage |
5V 12V 24V |
|
Output |
Differential; unidirectional. NPN PNP |
|
Product compatibility |
Compatible with imported and domestic systems and PLC |
|
Installation mode |
Wiring and plug |
|
Feature |
Full inspection of products, comprehensive upgrading of product quality, installation support technology, various plugs, imported components, pulse stability and long service life |
Details
Hand wheel Features:
1. Pulse integrated design, good appearance, clear font, imported components, no loss of pulse, long service life.
2. With emergency stop measurement and control support, all components are imported brands.
3. There is a definition drawing and anti-skid pad on the back, and the wear-resistant pad is inlaid with strong magnetic inside to facilitate adsorption on the machine.
Wiring Diagram Of Hand Wheel
|
No |
Wire color |
Signal |
Function |
No. |
Wire color |
Signal |
Function |
|
Hand wheel |
Red |
VCC |
Pulse positive voltage |
Axis selector Switch |
Pink |
5 |
5 Axis |
|
Black |
OV |
Pulse negative voltage |
Magnification switch |
Pink+Black |
6 |
6 Axis |
|
|
Green |
A |
Phase A |
Grey |
X1 |
Select 1 for magnification |
||
|
White |
B |
Phase B |
Grey+Black |
X10 |
Select 10 for magnification |
||
|
Purple |
A- |
Phase A inversion |
Orange |
X100 |
Select 100 for magnification |
||
|
Purple +black |
B- |
Phase B inversion |
Emergency stop switch |
Blue |
C |
Emergency stop C |
|
|
Axis selector Switch |
Yellow |
X |
X Axis |
Blue+black |
NC |
Emergency stop NC |
|
|
Yellow+Black |
Y |
Y Axis |
Work indicator |
Green+black |
LED+ |
Indicator positive voltage |
|
|
Brown |
Z |
Z Axis |
White+black |
LED- |
Indicator negative voltage |
||
|
Brown+Balck |
4 |
4 Axis |
Working end |
Orange+black |
COM |
Switch input common point |
Notes:
（Note that the unconnected wires must be cut out of bare copper and wrapped separately. Do not touch other wires, components and shells to avoid short circuit.）
1. The positive and negative lines of the encoder cannot be connected reversely. If the voltage is too high, it will burn out. It is usually 5V. For some systems, such as Mitsubishi, 12V and PLC, 24V. The specific voltage is connected according to the voltage confirmed during purchase.
2. Com point is the common point of handwheel switch, which must be connected, otherwise the switch cannot work normally.
3. The hand wheel shall be handled with care, and it is easy to be damaged by collision. Do not use too much force to rotate the code plate and switch, so as not to affect the service life.
4. When there is no a -, b-signal, the hand wheel indicator is not connected to power supply DC 5-24v.
5. Mitsubishi has no a -, b-signals, PLC has no a -, 8-signals and is not connected.
